I understand that the interface here closely mirrors pavucontrol but I wish there was a minimal view mode that showed the playback and the output devices all on one tab, as these two are what I am changing 99% of the time.
Currently, you have four tabs, and when you have a static setup where the config doesn't change much and maybe you even have inputs disabled, navigating these becomes somewhat of a burden. Recording and inputs are just empty tabs in the latter case, and even if they aren't, I often have to jump through these via keyboard here to access outputs.
Some suggestions that I think could help here:
- have
Playback and Outputs next to each other instead of Recording being between them
- hide
Recording and Input Devices tabs when there is nothing on the latter because of the configuration
- have a "minimal view" where the output devices are at the top and playback nodes are below on a single page
I understand that the interface here closely mirrors pavucontrol but I wish there was a minimal view mode that showed the playback and the output devices all on one tab, as these two are what I am changing 99% of the time.
Currently, you have four tabs, and when you have a static setup where the config doesn't change much and maybe you even have inputs disabled, navigating these becomes somewhat of a burden. Recording and inputs are just empty tabs in the latter case, and even if they aren't, I often have to jump through these via keyboard here to access outputs.
Some suggestions that I think could help here:
PlaybackandOutputsnext to each other instead ofRecordingbeing between themRecordingandInput Devicestabs when there is nothing on the latter because of the configuration