With the power injector you can power the CAN4VSCP bus and also power up to 16 CAN4VSCP modules using the inter module connector. This is a perfect companion board to use when you need to connect a number of CAN4VSCP boards in a cabinet and then connect them to the world.
It have two 120 ohm terminations that can be activated if needed and two RJ-45 connectors for easy connection.
The module has a resettable fuse that allow a maximum of 500 mA for all modules connected to the board. The fuse will trip at about 800 mA. This can be a good safety precaution for wired networks.
There is also two smaller versions available.
This project is part of the VSCP (Very Simple Control Protocol) project.
- Schematics reversion C
- Hardware design files is made in KiCad and can be found in the
kicaddirectory. Valid from reversion C of the hardware.- Gerber files for PCB production can be found in the
gerberdirectory (in thekicadfolder).
- Gerber files for PCB production can be found in the
- Eagle schema and board files for reversion A, B and C can be found in the
eagledirectory. They are no longer actively updated.
The firmware is developed in MPLAB X IDE using the XC8 compiler.
- Binary release files is available here
If you need support, please open an issue in the GitHub repository.
You can buy a ready made module from Grodans Paradis.