Kobra 2 Pro display does not show that a print job is currently running

[dudeden]

Good day.

I have an Anycubic Kobra 2 Pro running firmware version 3.1.4.

When I send a print job from OrcaSlicer over the network, the print starts successfully and everything works correctly. However, the printer's built-in display does not show that a print job is currently running.

Because of this, it is not possible to:

Adjust the Z-offset during printing;
Pause the print;
Cancel the print from the printer's touchscreen.

Is this a known issue, and is there any way to fix it or enable print status synchronization between OrcaSlicer/Klipper and the printer display?

Thank you.