Variants on KiCAD v10

[elektrinis]

Using ibom v2.11.0.
It correctly recognizes which variant is selected and skips DNP components (but only if I select "kicad_dnp" as "DNP field name" - was expecting this to work automatically on kicad v10), however it ignores other properties, like different values, mfg part number etc - I get the same value in the ibom, no matter which variant is selected.

[qu1ck]

only if I select "kicad_dnp" as "DNP field name" - was expecting this to work automatically on kicad v10

That is intended. If you want things to automatically be exlucded from bom then use "exclude from bom" feature in kicad.

it ignores other properties, like different values, mfg part number etc - I get the same value in the ibom, no matter which variant is selected.

Make sure you have updated pcb from schematic and those fields are actually different in pcb. You can check values in properties explorer in left column, they change when you change variants.

If you still run into this issue make a simple board that shows this problem and attach it here, I can not reproduce it.

[elektrinis]

Will do, thanks.

[elektrinis]

test project.zip

Here's a test project.
There's one diode and resistor, whose values change based on variant selected. they do change in the silkscreen when different variant is selected in pcb editor. My expectation is for ibom to reflect on that.
And one resistor that's DNP in one of variants.

No matter which variant is selected in the PCB editor, ibom generates the same thing, with no changes.
Expected behavior: values change based on selected variant (in pcb editor), one component should be not included in default variant.