Orange Pi Z2 GPIO

[Wrecker15]

Hey I see you are one of the few that seem to be using OPi Z2 to run octoprint. Have you had any luck finding and running any GPio plugins? I want to read a BME680 and control a fan based on it's readings but all the RPi.GPIO plugins I have found fail to install in Octoprint probably because of the different pin configs.

[nhchiu]

Sorry for the late reply.

I haven't used Octoprint on the Orange Pi. I'm not even sure if the ADXL345 resonance measuring can work.

I'll keep the repo updated when I have new findings. Thank you!

[gdattn]

I had problems with host mcu on opi_zero2w this article was a solution https://klipper.discourse.group/t/klipper-mcu-service-fails-to-start/12219 . Would you mind to add this link to readme.