Possibly cooked LimeSDR-USB

[wighthat]

Hi myriadrf,

I think I may have killed a Lime by failing to connect a fan while leaving it running. LimeQuickTest shows the board as failed. Can you confirm that the below output would indicate a dead board, please? Also, if there’s a better place to ask this kind of question can you please point me in the right direction?

Thanks

Mike

sbc002:~$ LimeQuickTest
[ TESTING STARTED ]
->Start time: Fri Oct 25 12:44:11 2019

->Device: LimeSDR-USB, media=USB 3.0, module=FX3, addr=1d50:6108, serial=0009072C00D52D1D
Serial Number: 0009072C00D52D1D

[ Clock Network Test ]
->FX3 GPIF clock test
Test results: 31171; 34927; 38683 - PASSED
->Si5351C test
CLK0: 17554 / 17554 - PASSED
CLK1: 17554 / 17554 - PASSED
CLK2: 17554 / 17554 - PASSED
CLK3: 17554 / 17554 - PASSED
CLK4: 17554 / 17554 - PASSED
CLK5: 17554 / 17554 - PASSED
CLK6: 17554 / 17554 - PASSED
->ADF4002 Test
Result: 10 - PASSED
->VCTCXO test
Results : 5112924 (min); 5113070 (max) - PASSED
->Clock Network Test PASSED

[ FPGA EEPROM Test ]
->Read EEPROM
->Read data: 12 0C 06 12 0C 06 02
->FPGA EEPROM Test PASSED

[ LMS7002M Test ]
->Perform Registers Test
->External Reset line test
Reg 0x20: Write value 0xFFFD, Read value 0xFFFD
Reg 0x20: value after reset 0x0FFFF
->LMS7002M Test PASSED

[ RF Loopback Test ]
Note: The test should be run without anything connected to RF ports
->Configure LMS
->Run Tests (TX_2-> LNA_L):
SetFrequencySXR(800 MHz) - cannot deliver frequency
->Run Tests (TX_1 -> LNA_W):
SetFrequencySXR(1800 MHz) - cannot deliver frequency
->Run Tests (TX_2-> LNA_H):
SetFrequencySXR(2500 MHz) - cannot deliver frequency
->RF Loopback Test FAILED

=> Board tests FAILED <=

Elapsed time: 1.52 seconds

[Jelly478558074]

LimeSDR USB，What is the name of the transmitting antenna?