power saving settings - WICAN PRO - best practice - EVCC

[austrogaucho]

are there any best practice settings for the power saving settings on the WICAN PRO for the following use cases ?

1.) SOC: I am using the WICAN PRO in combination with EVCC to charge my EV.
I need to get the SOC-value transmitted via MQTT as soon as the car is connected, the SOC should also be updated during the charging process.

2.) ODOMETER: as soon as the EV arrives at home it should connect to may WiFi and transmit the current mileage

[limatango79]

are there any best practice settings for the power saving settings on the WICAN PRO for the following use cases ?

1.) SOC: I am using the WICAN PRO in combination with EVCC to charge my EV. I need to get the SOC-value transmitted via MQTT as soon as the car is connected, the SOC should also be updated during the charging process.

2.) ODOMETER: as soon as the EV arrives at home it should connect to may WiFi and transmit the current mileage

I'm facing the same problem. Have you found a solution yet?

[darkenbula]

I have this setup with my wifes BYD ATTO 3
I currently have the Wican waking hourly when parked
It does transmit the SOC immediately when she arrives home , and from then on updates hourly, this works fine for EVCC as it calculates the approximate charge based on energy going into the vehicle. It would be nice if it could update more frequently while charging but this still works fine currently