[Feature Request]: how do i get retro go on the esp32 s3 devboard?

[Crafter-0X]

Description

I have the ili9341 dysplay and i already flashed the esp, but i diont know how to connect the display and sd card to the esp.
Does anyone know how?

Anything else?

No response

[Crafter-0X]

I connectet the esp to my pc and opened the serial monitor. It said retro go is ready, so the soft seems to work.

[PaulStetsun]

I have the same issue with esp32 s3 wroom 1 n16r8

[DynaMight1124]

If you've flashed the 'ESP32-S3 Dev kit' image then its compiled with the following pins: https://github.com/ducalex/retro-go/blob/master/components/retro-go/targets/esp32-s3-devkit/config.h

// SPI Display (back up working)
#define RG_GPIO_LCD_MISO GPIO_NUM_NC
#define RG_GPIO_LCD_MOSI GPIO_NUM_12
#define RG_GPIO_LCD_CLK GPIO_NUM_48
#define RG_GPIO_LCD_CS GPIO_NUM_NC
#define RG_GPIO_LCD_DC GPIO_NUM_47
#define RG_GPIO_LCD_BCKL GPIO_NUM_39
#define RG_GPIO_LCD_RST GPIO_NUM_3

//SD
#define RG_GPIO_SDSPI_MISO GPIO_NUM_9
#define RG_GPIO_SDSPI_MOSI GPIO_NUM_11
#define RG_GPIO_SDSPI_CLK GPIO_NUM_13
#define RG_GPIO_SDSPI_CS GPIO_NUM_10

So you'll need to ensure your display & sd card at a minimum are connected to the pins mentioned in the config. Its a generic setup, mostly kept to use a base for other targets, so you may find your chosen screen has issues with rotation and/or inversion, in which case you'll need to compile your own version based around your setup, but if you're lucky and get the right screen it should just work.