Version
2.0.0 (BETAv2) pre-release
Version type
uClibc (compatible), musl (experimental)
Version hash
No response
Issue description
On first boot, the image is flipped and all buttons are unresponsive. Start Script asks "Can you see this message". With all buttons being unresponsive, it goes into an infinite cycle of reboot & repeat of the startcript.
Device: Bittboy v2 (print on pcb says "MIYOO_V2.0")
Workaround:
I tested a bit and found I can use my Powkiddy v90 for the first two steps of firstboot script. I put the SD-card into the V90, switch it on and answere the first question "Can you see this message!" with "flipped" (even though it is NOT flipped on the v90). Then (after reboot) it asks me if the D-pad is working correctly. I choose the answere "No". It goes into another reboot. At this stage I switch it off and put the SD-card back into the Bittboy. From there on the buttons on the Bittboy are responsive and I can complete the firstboot-script on the Bittboy.
With a bit futher testing I found out that it seems I don't need the Powkiddy V90 for the workaround. It looks like it is sufficient to do this step before putting the SD-card into the Bittboy v2 for the first time:
On the Boot-partition I edit the file "console.cfg". I replace its content with the following line:
CONSOLE_VARIANT=bittboy2x_v2
Steps to reproduce
see above
What device are you using?
BittBoy v2
Relevant log outputs
Issues' terms
Version
2.0.0 (BETAv2) pre-release
Version type
uClibc (compatible), musl (experimental)
Version hash
No response
Issue description
On first boot, the image is flipped and all buttons are unresponsive. Start Script asks "Can you see this message". With all buttons being unresponsive, it goes into an infinite cycle of reboot & repeat of the startcript.
Device: Bittboy v2 (print on pcb says "MIYOO_V2.0")
Workaround:
I tested a bit and found I can use my Powkiddy v90 for the first two steps of firstboot script. I put the SD-card into the V90, switch it on and answere the first question "Can you see this message!" with "flipped" (even though it is NOT flipped on the v90). Then (after reboot) it asks me if the D-pad is working correctly. I choose the answere "No". It goes into another reboot. At this stage I switch it off and put the SD-card back into the Bittboy. From there on the buttons on the Bittboy are responsive and I can complete the firstboot-script on the Bittboy.
With a bit futher testing I found out that it seems I don't need the Powkiddy V90 for the workaround. It looks like it is sufficient to do this step before putting the SD-card into the Bittboy v2 for the first time:
On the Boot-partition I edit the file "console.cfg". I replace its content with the following line:
CONSOLE_VARIANT=bittboy2x_v2
Steps to reproduce
see above
What device are you using?
BittBoy v2
Relevant log outputs
Issues' terms