UPDI documentation

[technoblogy]

On the page:

https://github.com/SpenceKonde/AVR-Guidance/blob/master/UPDI/jtag2updi.md

However, if your choice is between a resistor and a silicon diode, as opposed to as Schottky one, always pick the Schottky, because the silicon diode will not work.

should presumably read:

However, if your choice is between a resistor and a silicon diode, as opposed to a Schottky one, always pick the resistor, because the silicon diode will not work.

[SpenceKonde]

Agree would you mind PRing it as I've got a lot going on atm

…

____________ Spence Konde Azzy’S Electronics New products! Check them out at tindie.com/stores/DrAzzy GitHub: github.com/SpenceKonde ATTinyCore: Arduino support for almost every ATTiny microcontroller Contact: ***@***.***

On Thu, Jan 12, 2023, 05:40 David Johnson-Davies ***@***.***> wrote: On the page: https://github.com/SpenceKonde/AVR-Guidance/blob/master/UPDI/jtag2updi.md However, if your choice is between a resistor and a silicon diode, as opposed to as Schottky one, always pick the Schottky, because the silicon diode will not work. should presumably read: However, if your choice is between a resistor and a silicon diode, as opposed to a Schottky one, always pick the resistor, because the silicon diode will not work. — Reply to this email directly, view it on GitHub <#10>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ABTXEW25OJCDOYO2PTDQYXTWR7NQHANCNFSM6AAAAAATZC4WHU> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>