PIO build firmwares dont work

[GerardoFJ]

Hi, I have a problem. For some reason, when I build the firmware for my board, it doesn't work. The only firmware that works is the repo test build: 'hoverboard autodetect GD32F130 tx=PA2, rx=PA3.bin'.

However, when I try to build the firmware with PlatformIO (PIO) using my current config, it doesn't work; it fails to communicate with the ESP32.

With the published build, it works fine, which is strange. I also tried to build the 2.10 config with some port modifications to match my board mapping, but that didn't work either. I suspect the firmwares I'm building with PIO are not working correctly. What could be the cause?

[GerardoFJ]

Config file that i build

[RoboDurden]

Can you debug the code ?
Like setting a breakpoint to the beginning of main().

Read about stmstudio or mcuviewer in our wiki.

[GerardoFJ]

Can you debug the code ?
Like setting a breakpoint to the beginning of main().

Read about stmstudio or mcuviewer in our wiki.

It is possible to debug the code with stm32cube? Or because is generic micro it isn't possible?

[RoboDurden]

Those who ask many questions understand little.

[ledbetterjustin1281]

its the esp uart. i cant remember if its uart0 or uart1. Change that and it will work