Show running configuration

[bebehei]

I have plenty of Juniper+bird experience, but I'm just starting with FRR.

If I start with frr and type in the following commands:

user@srv:~# vtysh 

Hello, this is FRRouting (version 10.3.1).
Copyright 1996-2005 Kunihiro Ishiguro, et al.

srv# configure
srv(config)# route-map MAP_BGP_IN permit 1
srv(config-route-map)# show ?

In juniper you could just run show and it shows the current configuration tree down to the leaves.

How can I display the current configuration in FRR? Is this supported? Or do I always need to exit to the top, run write and then check the configuration file?

[mjstapp]

you should be able to use do show runn when within a configuration submode

[bebehei]

Thanks, but then I get the full config dump. Is there any possibility to limit it to the current level?

[donaldsharp]

no