CTs using wrong calibaration value

[jsaintamour]

Im having an issue where calibrated values im entering into my .yaml are not being used by the energy meter on install. Instead it seems like its grabbing the value for the corresponding "B" value from the other bank of sensors.

CTs 3-4 are not used

CT1, 5 and 6 are reporting the correct values, however CT2 is attempting to use CT5's calibration value even though its correct value (for reference CT 1 and 2 are on the same wire right now, based on the calibration numbers in yaml should be reporting near identical values). Im sure theres a setting or value im missing somewhere but after 4 hours of searching im coming up short.

Any help would be appreciated

[CircuitSetup]

I believe there is an issue with how calibration values are being saved and retained in flash memory.

For now, if you want a specific value for gain, make sure it is in the config file. Hit the clear button for that set of CTs in the ESPHome meter device (in Home Assistant). ESPHome takes priority of calibration values in flash over whats in the config file.